Weave phones work well with Netgear ProSafe Routers. Follow the guide below to configure the Netgear to allow Weave traffic to flow correctly.
Traffic Shaping/QoS for VolP
Go to Advanced > QoS Engine. This will bring up your QoS settings (bandwidth management). Here is our information needed to configure:
Weave's FQDN: allow.us1.weavephone.net/
If the router doesn't support FQDN, you will need to add all of these Weave IP Addresses to your router/firewall (A list).
If you'd like to create rule sets based on specific ports, here are the ones we use:
443 (TCP) - Weave Software and Phone Configuration/Provisioning
5060/5061 (TCP/UDP) - SIP
5222 (TCP/UDP) - SIP Signaling
7000 (UDP/TCP - SIP Signaling
16384-40000 (UDP) - Real Time Voice
Recommended Configuration Changes
- Ensure SIP ALG is disabled (Netgear Portal > Advanced > WAN Setup)